Hi Ram and Amit,
We are in BW 3.5 and the datasource is 2LIS_02_ITM to purchasing ODS item level in BW.
We will have to load all the existing data to correct it in the target. We also have to reload all data that flows to other three ODS to correct it. All ODS is pulling delta now. There is a data field to use it in the set up table. Lets say if I run it for one month or few months in the set up table, I should immediately run infopackage to load in BW after set up table, right? Is that how the sequence for each data load? I am also concerned about further data flow from ODS1 to other ODS? Will that pull data automatically once Item ODS loads on each run? or Do I have to run separate repair load for further processing? Other data targets also pulls data from schedule line, good receipt etc besides data from ITEM ODS. Due to that reason, I am also concerned if any possible conflict when I do repair load to further data targets. All key figures are overwrite on all the ODS.
Thanks